Wichita State University CAD/CAM Laboratory
California CATIA Summer Session From 6/7/2010 to 7/24/2010


Set	Title of Workshop	Course	Line	From		To	Day(s)	Begin		End

01	Part Design & Sketcher	ENGR 250P	35544	1:30	-	3:30	MW - PM	6/7/2010	-	7/19/2010
02	Part Design & Sketcher	ENGR 250P	35546	6:30	-	8:30	MW - PM	6/7/2010	-	7/19/2010
03	Part Design & Sketcher	ENGR 250P	35548	6:30	-	8:30	TTH - PM	6/8/2010	-	7/15/2010
04	Part Design & Sketcher	ENGR 250P	35549	5:30	-	9:30	F - PM	6/11/2010	-	7/23/2010
05	Part Design & Sketcher	ENGR 250P	35550	8:30	-	12:30	SAT - AM	6/12/2010	-	7/24/2010

06	Assembly Design	ENGR 250R	35551	8:00	-	10:00	MW - AM	6/7/2010	-	7/19/2010
07	Assembly Design	ENGR 250R	35553	4:00	-	6:00	TTH - PM	6/8/2010	-	7/15/2010
08	Assembly Design	ENGR 250R	35554	6:30	-	8:30	TTH - PM	6/8/2010	-	7/15/2010
09	Drafting	ENGR 250S	35556	4:00	-	6:00	MW - PM	6/7/2010	-	7/19/2010
10	Drafting	ENGR 250S	35557	6:30	-	8:30	TTH - PM	6/8/2010	-	7/15/2010

11	Wireframe & Surfaces	ENGR 250U	35559	6:30	-	8:30	MW - PM	6/7/2010	-	7/19/2010
12	Wireframe & Surfaces	ENGR 250U	35560	10:30	-	12:30	TTH - AM	6/8/2010	-	7/15/2010
13	Functional Tolerancing & Annotation	ENGR 250W	35567	4:00	-	6:00	MW - PM	6/7/2010	-	7/19/2010
14	Functional Tolerancing & Annotation	ENGR 250W	35568	8:00	-	10:00	TTH - AM	6/12/2010	-	7/24/2010
15	Fitting Simulation & Kinematics	ENGR 250X	35569	10:30	-	12:30	MW - AM	6/7/2010	-	7/19/2010

16	Fitting Simulation & Kinematics	ENGR 250X	35569	1:30	-	3:30	TTH - PM	6/8/2010	-	7/15/2010

Classes are held in the CAD/CAM Laboratory at 39 Parker, Irvine, CA 92618. Enrollment is limited to 9-14 students per class section. Please enroll at least two weeks before the workshop begins and contact the CAD/CAM Lab for any scheduling changes.

FOR ENROLLMENT INFORMATION, OR TO ENROLL, CONTACT:
Glenda Campbell, Technical Coordinator
Telephone: +1 316 978 3283
E-mail: glenda@cadcamlab.org